3.3.0 en.html
Редактировал(а) writer 2022/08/19 19:00
Client: build v. 3.3.0.20031
Server: build v. 3.3.0
- Analog inputs added (hardware support presents for PLCM-E3 in current device generation).
2. Dynamic motors bound to axis disabling/enabling implemented.
3. Possibility to deskew gantry axes added. It is possible to set program shift of the home sensor for selected motor.
4. Wizard implemented that allows to check gantry axes alignment. Sequential move to four positions forming rectangle is performed on run. Execution is stopped at every position what allows to make a mark on the sheet. When wizard's execution is finished it is necessary to measure two rectangle's diagonals and enter actual values. Wizard calculates a shift of the home sensor and show recommended setting.
5. Softlimits can be separately enabled/disabled.
6. Posibility to mark axes as homed added.
7. It is posible to set a delay between STEP pulse and DIR switching. Parameter's value may depend on the model of driver used.
8. Move to machine zero executed for homed axes only. This command's logic can be edited by modifying M118 macro.
9. Added message that several devices with identical IP are discovered in the network.
10. Macros and background operations API was extended.
11. SwapToolSlots function added to macros API that allows to implement toolchange algorithm when double-arm toolchanger is used.
12. Some messages for default macros localized.
13. CPU load reduced in some cases during G-code execution.
14. Smooth stopping when Stop button pressed during homing implemented.
15. Delays are decreased for Modbus connections with certain speeds.
16. Fixed an issue when the COM port wasn't changed in the Modbus master window.
17. Diagnostics tab visually refactored for all modules.
18. Minor bug fixes and improvements.