Skip to Content
Last modified by writer on 2023/09/06 20:00
From version 3.1
edited by writer
on 2023/02/09 16:36
Change comment: There is no comment for this version
To version 4.1
edited by writer
on 2023/06/14 14:28
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -6,11 +6,8 @@
6 6  
7 7  The selection and adjustment of the operating mode is carried out on the tab “Configuration” → “Settings” → “Oxy-Fuel”.
8 8  
9 -[[image:2019-09-06 11_44_28-Settings.png||alt="Window ~"Settings~" of the oxy-fuel module" data-xwiki-image-style-alignment="center" height="558" width="900"]]
9 +[[Window "Settings" of the oxy-fuel module>>image:2019-09-06 11_44_28-Settings.png||alt="Window ~"Settings~" of the oxy-fuel module" data-xwiki-image-style-alignment="center" height="558" width="900"]]
10 10  
11 -(% class="imagetext" style="color: gray; text-align: center;" %)
12 -Window "Settings" of the oxy-fuel module
13 -
14 14  ===== (% style="color:#007a7a" %)**External Z Control**(%%) =====
15 15  
16 16  This mode involves the use of a stand-alone flame torch height controller (CHC-400 and others). The Z axis (including the motor) is controlled in this mode by the autonomous axis controller.
... ... @@ -43,9 +43,6 @@
43 43  
44 44  Used in the absence of both standalone Z axis controllers and torch torch height controllers using the UP/DOWN protocol. Correction of the torch height above the metal in this mode is carried out manually using the "Up" and "Down" buttons.
45 45  
46 -[[image:image2019-9-10_14-6-4.png||alt="Buttons for height correction in manual mode of the Z axis" data-xwiki-image-style-alignment="center"]]
43 +[[Buttons for height correction in manual mode of the Z axis>>image:image2019-9-10_14-6-4.png||alt="Buttons for height correction in manual mode of the Z axis" data-xwiki-image-style-alignment="center"]]
47 47  
48 -(% class="imagetext" style="color: gray; text-align: center;" %)
49 -Buttons for height correction in manual mode of the Z axis
50 -
51 51  In manual control mode, no additional input and output signals are required. When you press the Up and Down buttons, the Z axis moves with the specified height adjustment speed.