Skip to Content
Last modified by writer on 2023/12/27 16:38
From version 6.1
edited by writer
on 2023/12/27 16:38
Change comment: There is no comment for this version
To version 5.1
edited by writer
on 2023/09/06 12:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2,7 +2,7 @@
2 2  
3 3  [[View of the tab with the ohmic sensor settings>>image:2020-12-02 10_58_29-Settings.png||alt="View of the tab with the ohmic sensor settings" data-xwiki-image-style-alignment="center" height="529" width="1000"]]
4 4  
5 -You must to put a check in front of the inscription "Use PLL-R2 ohmic sensor" before setting. It is necessary so that the program allows you to configure the use of an ohmic sensor:
5 +You need to configure to use an ohmic sensor:
6 6  
7 7  1. (% style="color:#009797" %)//**Probing**//(%%)// input (main)//
8 8  Input of the probing signal from the protective screen (cap).
... ... @@ -19,6 +19,8 @@
19 19  
20 20  [[Probing input (main) in the settings field and on the scheme>>image:2020-12-02 11_25_24-Settings.png||alt="Probing input (main) in the settings field and on the scheme" data-xwiki-image-style-alignment="center" height="541" width="1000"]]
21 21  
22 +You must to put a check in front of the inscription "Use PLL-R2 ohmic sensor" after setting. It is necessary so that the program will take into account the changes made.
23 +
22 22  [[Probing input (reserve) in the settings field and on the scheme>>image:2020-12-02 11_35_11-Settings.png||alt="Probing input (reserved) in the settings field and on the scheme" data-xwiki-image-style-alignment="center" height="541" width="1000"]]
23 23  
24 24  The (% style="color:#009797" %)//**dZ**//(%%) value can be measured by measuring the distance in millimeters or inches on the device itself manually and entering the value in the program, or automatically.