Skip to Content
Last modified by writer on 2024/09/10 14:00
From version 3.1
edited by writer
on 2024/09/10 13:49
Change comment: There is no comment for this version
To version 1.1
edited by writer
on 2024/09/10 13:28
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -Setting up network addresses in PUMOTIX
1 +Настройка сетевых адресов в PUMOTIX
Content
... ... @@ -20,10 +20,11 @@
20 20  
21 21  Select a motion controller from the list. The system will begin updating the device firmware if necessary. Just wait until the operation is completed. The PUMOTIX will automatically check the network settings of the computer and the selected controller. If problems with network settings are detected, PUMOTIX will display a corresponding message to the user with a proposal to change the device address. When you click on the “Change Address” button (or on the pencil icon in the “Device Address (IPv4)” field), an additional window for entering network settings for the controller will open.
22 22  
23 +[[image:Controller_change_IP.png||data-xwiki-image-style-alignment="center" height="563" width="1000"]]
23 23  
24 24  The choice of mode for obtaining network settings depends on the switching equipment used. If you connected the controllers to a router with the DHCP function (automatic assignment of network settings) enabled, then simply select “Obtain an IP address from a DHCP server.” You also need to make sure that the computer’s network adapter settings are also set to automatically obtain an address. In this case, all hosts on the local network will be issued addresses by the router’s DHCP server.
25 25  
26 -[[image:Obtain from DHCP server.png||data-xwiki-image-style-alignment="center" height="263" width="350"]]
27 +[[image:Auto_DHCP_Setting.png||data-xwiki-image-style-alignment="center" height="263" width="350"]]
27 27  
28 28  If you used a classic switch to connect devices into a network, then you will have to take care of issuing network addresses to each of the nodes manually. The basic rules for manually (statically) assigning IP addresses to nodes on a network are as follows:
29 29  
... ... @@ -52,4 +52,4 @@
52 52  
53 53  Detailed instructions with screenshots for setting up the device’s IP address are available in the user manual for this device.
54 54  
55 ->(% style="font-size:14px" %)If you are unable to configure network addresses, contact your organization's system administrator or [[PUMOTIX technical support service>>doc:Руководство пользователя.Ответы на типовые вопросы.Формируем логи PUMOTIX.WebHome]] for help at [[support@pumotix.ru>>mailto:support@pumotix.ru]]
56 +>(% style="font-size:14px" %)f you are unable to configure network addresses, contact your organization's system administrator or [[PUMOTIX technical support service>>doc:Руководство пользователя.Ответы на типовые вопросы.Формируем логи PUMOTIX.WebHome]] for help at [[support@pumotix.ru>>mailto:support@pumotix.ru]]