Skip to Content
Last modified by writer on 2024/09/10 14:00
From version 4.1
edited by writer
on 2024/09/10 14:00
Change comment: There is no comment for this version
To version 3.1
edited by writer
on 2024/09/10 13:49
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -20,7 +20,6 @@
20 20  
21 21  Select a motion controller from the list. The system will begin updating the device firmware if necessary. Just wait until the operation is completed. The PUMOTIX will automatically check the network settings of the computer and the selected controller. If problems with network settings are detected, PUMOTIX will display a corresponding message to the user with a proposal to change the device address. When you click on the “Change Address” button (or on the pencil icon in the “Device Address (IPv4)” field), an additional window for entering network settings for the controller will open.
22 22  
23 -[[image:Change controller IP-address.png||data-xwiki-image-style-alignment="center" height="528" width="1000"]]
24 24  
25 25  The choice of mode for obtaining network settings depends on the switching equipment used. If you connected the controllers to a router with the DHCP function (automatic assignment of network settings) enabled, then simply select “Obtain an IP address from a DHCP server.” You also need to make sure that the computer’s network adapter settings are also set to automatically obtain an address. In this case, all hosts on the local network will be issued addresses by the router’s DHCP server.
26 26  
... ... @@ -40,7 +40,7 @@
40 40  |(% style="width:222px" %)Motion controller|(% style="width:125px" %)192.168.10.10|(% style="width:125px" %)255.255.255.0
41 41  |(% style="width:222px" %)Height controller|(% style="width:125px" %)192.168.10.12|(% style="width:125px" %)255.255.255.0
42 42  
43 -[[image:Use the following IP address.png||data-xwiki-image-style-alignment="center" height="263" width="350"]]
42 +[[image:Static_IP_Setting.png||data-xwiki-image-style-alignment="center" height="263" width="350"]]
44 44  
45 45  Set the addresses in the table for your computer's network adapter, motion controller, and torch height controller. Configuring the IP addresses of the height controller is done in the same way.
46 46  
... ... @@ -49,7 +49,7 @@
49 49  * the device has been selected in PUMOTIX, but is temporarily not online (the controller's power may have been turned off);
50 50  * the device is selected and online, but the device's network settings still conflict with the network settings of the computer running PUMOTIX.
51 51  
52 -[[image:Connection indicators.png||data-xwiki-image-style-alignment="center" height="250" width="683"]]
51 +[[image:Conctroller_Connection_State.png||data-xwiki-image-style-alignment="center" height="250" width="553"]]
53 53  
54 54  Detailed instructions with screenshots for setting up the device’s IP address are available in the user manual for this device.
55 55