Wiki source code of Плазменная резка (фоновые операции)

Last modified by writer on 2023/09/08 19:07

version	line-number	content
5.2	1	===== bool Is_THC_Mode () =====
1.1	2
5.2	3	Checks if PUMOTIX is in plasma cutting mode.
1.1	4
5.2	5	Return value:
1.1	6
5.2	7	* true - if PUMOTIX is in plasma cutting mode;
	8	* false - if another mode is active.
1.1	9
5.2	10	===== number GetCurrentVoltage () =====
1.1	11
5.2	12	Getting the current voltage value in plasma cutting mode.
1.1	13
5.2	14	Return value:
1.1	15
5.2	16	* current voltage, V.
1.1	17
5.2	18	===== number GetDesiredVoltage () =====
1.1	19
5.2	20	Obtaining the set value of the desired voltage in the plasma cutting mode.
1.1	21
5.2	22	Return value:
1.1	23
5.2	24	* desired voltage, V.
1.1	25
5.2	26	===== void SetDesiredVoltage (number value) =====
1.1	27
5.2	28	Setting the desired voltage in plasma cutting mode.
1.1	29
5.2	30	Options:
1.1	31
5.2	32	* number value - the desired voltage, V.
1.1	33
5.2	34	===== bool GetThcTorchOn () =====
3.1	35
5.2	36	Allows you to check if the torch is on in plasma mode.
3.1	37
5.2	38	Return value:
3.1	39
5.2	40	* true – if the torch is on in plasma mode.
3.1	41
5.2	42	===== bool UseOmichSensor () =====
1.1	43
5.2	44	Allows you to check if the using ohmic sensor PLL-R2 is enabled in the Settings.
1.1	45
5.2	46	Return value:
1.1	47
5.2	48	* true – if the using ohmic sensor PLL-R2 is enabled.
1.1	49
5.2	50	===== number GetOmichSensorDelta () =====
1.1	51
5.2	52	Getting the dZ value specified in the settings of the ohmic sensor.
1.1	53
5.2	54	Return value:
1.1	55
5.2	56	* dZ value specified in the settings of the ohmic sensor.
1.1	57
5.2	58	===== void SetOmichSensorDelta (number value) =====
1.1	59
5.2	60	Setting the dZ value for ohmic sensor.
1.1	61
5.2	62	Options:
1.1	63
5.2	64	* number value – dZ value for ohmic sensor.

Wiki source code of Плазменная резка (фоновые операции)

Page Tree