Skip to Content
Last modified by writer on 2022/11/02 14:13
Hide last authors
writer 6.1 1 (% style="color:#a0be2d" %)//**G73 X- Y- Z- R- Q- <L->**//
knetyaga 1.1 2
writer 7.1 3 * R – retract position along the Z axis;
4 * Q – delta increment along the Z axis;
5 * L – repeat count.
writer 6.1 6
writer 7.1 7 The (% style="color:#a0be2d" %)//**G73 **//(%%)cycle is drilling or milling with chip breaking. This cycle takes a Q number which represents a delta increment along the Z axis.
knetyaga 1.1 8
writer 7.1 9 1. Preliminary motion:
10 If the current Z position is below the R position, The Z axis does a rapid move to the R position.
11 Move to the X Y coordinates.
12 1. Move the Z-axis only at the current feed rate downward by delta or to the Z position, whichever is less deep.
13 1. Rapid up a bit.
14 1. Repeat steps 2 and 3 until the Z position is reached at step 2.
15 1. The Z axis does a rapid move to the R position.
knetyaga 1.1 16
writer 7.1 17 {{error title="**It is an error if:**"}}
18 * the Q number is negative or zero;
19 * the R number is not specified.
writer 3.1 20 {{/error}}
writer 7.1 21
22 (% class="auto-cursor-target" %)
23