Skip to Content
Last modified by writer on 2023/09/07 15:18
From version 1.1
edited by writer
on 2023/09/06 18:48
Change comment: There is no comment for this version
To version 2.1
edited by writer
on 2023/09/07 15:18
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -32,7 +32,7 @@
32 32  
33 33  1. Raising to a height SafeZ, if it has been set.
34 34  1. Spindle shutdown.
35 -1. Moving to the tool change point ([[more...>>doc:Руководство пользователя.Ответы на типовые вопросы.Для чего нужна «Таблица инструментов»?.WebHome]]).
35 +1. Moving to the tool change point ([[more...>>doc:Руководство пользователя.Ответы на типовые вопросы.Для чего нужна "Таблица инструментов"?.WebHome]]).
36 36  1. Turn on standby mode (the "Changing" indicator flashes in yellow).
37 37  [[image:2019-09-05 08_34_14-PUMOTIX x64 Администратор.png||data-xwiki-image-style-alignment="center"]]All previous operations are performed automatically, receiving instructions from the macro.
38 38  1. Replacement of the cutting tool (milling cutter) - is carried out manually by the operator, subsequent measurements are optional.
... ... @@ -54,7 +54,7 @@
54 54  1. Spindle shutdown.
55 55  1. Moving to the tool change point.
56 56  
57 -To analyze further actions, look at the “Tool Table” window directly in the PUMOTIX program (“Configuration” → [["Tool Table">>doc:Руководство пользователя.Ответы на типовые вопросы.Для чего нужна «Таблица инструментов»?.WebHome]]).
57 +To analyze further actions, look at the “Tool Table” window directly in the PUMOTIX program (“Configuration” → [["Tool Table">>doc:Руководство пользователя.Ответы на типовые вопросы.Для чего нужна "Таблица инструментов"?.WebHome]]).
58 58  
59 59  [[image:Tool_Table_Window_en.png||data-xwiki-image-style-alignment="center" height="527" width="1000"]]
60 60