Wiki source code of Настройка PLCM-R1
Last modified by writer on 2022/08/19 14:24
Show last authors
author | version | line-number | content |
---|---|---|---|
1 | 1. **Using power injector connect the pendant according to the diagram below.** | ||
2 | The axis selection LEDs should light up if connected correctly. This indicates that the remote control is turned on, but is not yet in contact with the control program.((( | ||
3 | [[image:PLCM-R1_en.png||data-xwiki-image-style-alignment="center" height="400" width="513"]] | ||
4 | ))) | ||
5 | 1. ((( | ||
6 | **Run PUMOTIX.** | ||
7 | Open Plugins Configuration window via menu "Plugins" → “Plugins Configuration” and set the "Active" sign for plugin "CNC pendants". | ||
8 | |||
9 | [[image:Pednant plugin On.png||data-xwiki-image-style-alignment="center" height="200" width="584"]] | ||
10 | |||
11 | After that open the CNC pendants window for PLCM-R1 setup via "Plugins" menu. | ||
12 | |||
13 | [[image:CNC pendant menu.png||data-xwiki-image-style-alignment="center" height="100" width="400"]] | ||
14 | ))) | ||
15 | 1. ((( | ||
16 | **Setup the PLCM-R1 with PUMOTUX using the plugin.** | ||
17 | Select the pendant on the "Selected device" field. The list of devices is loaded automatically depending on the pendants connected to the PC. | ||
18 | You must make a selection in the “Selected profile” field to configure the pendant. The list of profiles is loaded automatically depending on the selected module. PUMOTIX comes with default PLCM-R1 configurations but you can also create a custom configuration. | ||
19 | |||
20 | [[image:Empty Pendant plugin Window.png||data-xwiki-image-style-alignment="center" height="464" width="900"]] | ||
21 | |||
22 | Next you will see on your screen the model of pendant and fields with commands for pendant buttons. Setup the pendant and press the "Apply" button. | ||
23 | [[image:PLCM-R1_setup_window.png||data-xwiki-image-style-alignment="center" height="655" width="900"]] | ||
24 | ))) | ||
25 | 1. ((( | ||
26 | **Establish a connection between the PC and the pendant.** | ||
27 | If you have configured the pendant but all the axis LEDs continue to light, you will need to change the PLCM-R1 network settings. Use the settings button in the upper right corner of the window to do this. | ||
28 | [[image:PLCM-R1_setings_child_window.png||data-xwiki-image-style-alignment="center" height="267" width="350"]] | ||
29 | |||
30 | Set the IP address the same subnet with your PC (example: PC IP address is 192.168.10.5, mask 255.255.255.0, set the pendant IP address 192.168.10.23, mask 255.255.255.0, or another free IP address). Press the "Apply". | ||
31 | After setting applying pendant LED "Connect" will light up. | ||
32 | ))) | ||
33 | 1. **Close the settings window - your pendant is ready to use.** |