Skip to Content
Last modified by writer on 2023/09/06 14:02
From version 5.1
edited by writer
on 2023/02/09 13:44
Change comment: There is no comment for this version
To version 6.1
edited by writer
on 2023/02/09 13:45
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -69,6 +69,8 @@
69 69  
70 70  * **'Stop' Signal**
71 71  Signal of hardware input “Stop”. It can be used, for example, to stop the execution of G-Code when the metal touches the nozzle or sensor ring of the capacitive torch height controller. When the input is triggered, there is no loss of coordinates, the G-Code can be continued from the stop.
72 +)))
73 +
72 72  * **Z Correction**
73 73  Displays the presence or absence of nozzle height correction above the metal. Gas cutting height control is carried out in three modes:
74 74  • external Z control;
... ... @@ -85,4 +85,3 @@
85 85  Height correction indicator cutting up. In the autonomous axis mode or manual control, next to the indicator is a button for manual correction of the torch height up.
86 86  * **THC Down (DOWN)**
87 87  Height correction indicator cutting down. In the autonomous axis mode or manual control, next to the indicator is a button for manual correction of the torch height down.
88 -)))