Skip to Content
Last modified by writer on 2023/09/06 14:02
From version 9.1
edited by writer
on 2023/06/07 15:21
Change comment: There is no comment for this version
To version 5.1
edited by writer
on 2023/02/09 13:44
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -45,7 +45,8 @@
45 45  “Diagnostics” Tab
46 46  
47 47  (% class="relative-table wrapped" style="width:100.0%" %)
48 -|(% style="border-width:0.0px; width:110px" %)(((
48 +|(% style="border-width:0.0px" %)(% style="border-width: 0.0px;" %)
49 +(((
49 49  [[image:2019-09-06 12_19_55-PUMOTIX x64 Administrator.png||alt="Basic display panel module signals" data-xwiki-image-style-alignment="center" height="771" width="150"]]
50 50  
51 51  (% class="imagetext" style="color: gray; text-align: center;" %)
... ... @@ -68,8 +68,6 @@
68 68  
69 69  * **'Stop' Signal**
70 70  Signal of hardware input “Stop”. It can be used, for example, to stop the execution of G-Code when the metal touches the nozzle or sensor ring of the capacitive torch height controller. When the input is triggered, there is no loss of coordinates, the G-Code can be continued from the stop.
71 -)))
72 -
73 73  * **Z Correction**
74 74  Displays the presence or absence of nozzle height correction above the metal. Gas cutting height control is carried out in three modes:
75 75  • external Z control;
... ... @@ -86,3 +86,4 @@
86 86  Height correction indicator cutting up. In the autonomous axis mode or manual control, next to the indicator is a button for manual correction of the torch height up.
87 87  * **THC Down (DOWN)**
88 88  Height correction indicator cutting down. In the autonomous axis mode or manual control, next to the indicator is a button for manual correction of the torch height down.
88 +)))