Ohmic Sensor Settings

The ohmic sensor settings is a function available in the PUMOTIX plasma module without purchasing additional options. The settings block can be found in the menu "Configuration" → "Settings" → "Plasma".

View of the tab with the ohmic sensor settings

You need to configure to use an ohmic sensor:

1. Probing input (main)
   Input of the probing signal from the protective screen (cap).
2. Probing input (reserve)
   Allows to correctly complete the probe task if the main probing sensor didn't work for some reason.
3. Enable output
   Output for switching on the ohmic sensor measuring circuit.
4. dZ correction value, units
   The distance when lifting the cutter before triggering the reserve probing sensor. The height adjustment is applied automatically when the backup sensor is activated.
5. Torch Detachment input
   The G-code executing is automatically stopped with the corresponding message when a signal is triggered . You can continue from the stop position after restoring the cutter position.

For easy setup, the fields and scheme are connected by links showing where a particular sensor element is located on the torch. 

Probing input (main) in the settings field and on the scheme

You must to put a check in front of the inscription "Use PLL-R2 ohmic sensor" after setting. It is necessary so that the program will take into account the changes made.