G80: Cancellation of Drilling, Boring, Threading Cycles
Last modified by writer on 2023/09/12 16:37
G80 – command cancel canned cycles.
The G80 command is included in modal group 1, so specifying any other command from modal group 1 also cancels the canned cycle.
G80 example:
G90 G81 X1 Y1 Z1.5 R2.8 (canned cycle)
G80 (cancellation of a canned cycle)
G0 X0 Y0 Z0 (fast moving to the origin)
G80 (cancellation of a canned cycle)
G0 X0 Y0 Z0 (fast moving to the origin)
The following code produces the same result as the previous one.
G0 example:
G90 G81 X1 Y1 Z1.5 R2.8 (canned cycle)
G0 X0 Y0 Z0 (fast moving to the origin)
G0 X0 Y0 Z0 (fast moving to the origin)
The advantage of the first option is that the G80 command explicitly disables the G81 canned cycle. In this case, it is necessary to enable the displacement mode on the next line with the G0 command or another displacement mode selection command.
If the canned cycle has not been disabled by the G80 command or another command, the canned cycle will be repeated using the following code block containing the parameters X, Y or Z.