Skip to Content
Last modified by writer on 2023/09/08 18:38
From version 2.1
edited by writer
on 2022/11/03 17:49
Change comment: There is no comment for this version
To version 4.1
edited by writer
on 2023/09/08 18:38
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,4 +1,4 @@
1 -==== **number SpindleGetCurRPM()** ====
1 +===== number SpindleGetCurRPM() =====
2 2  
3 3  Getting the current spindle speed.
4 4  
... ... @@ -6,7 +6,7 @@
6 6  
7 7  * current spindle speed, rpm.
8 8  
9 -==== **number GetGCodeSpindleRPM()** ====
9 +===== number GetGCodeSpindleRPM() =====
10 10  
11 11  Getting the current spindle speed specified in the G-code.
12 12  
... ... @@ -14,7 +14,7 @@
14 14  
15 15  * current spindle speed specified in the G-code, rpm.
16 16  
17 -==== **number SpindleGetOverridePercent()** ====
17 +===== number SpindleGetOverridePercent() =====
18 18  
19 19  Obtaining a percentage of overriding the current spindle speed.
20 20  
... ... @@ -22,15 +22,15 @@
22 22  
23 23  * the percentage that the actual spindle speed is from the specified.
24 24  
25 -==== **void SpindleStartCW()** ====
25 +===== void SpindleStartCW() =====
26 26  
27 27  Turn on the spindle clockwise.
28 28  
29 -==== **void SpindleStartCCW()** ====
29 +===== void SpindleStartCCW() =====
30 30  
31 31  Turn on spindle rotation counterclockwise.
32 32  
33 -==== **void SpindleStartCWRPM(number rpm)** ====
33 +===== void SpindleStartCWRPM(number rpm) =====
34 34  
35 35  Turns on the spindle clockwise at the indicated rotation speed.
36 36  
... ... @@ -38,7 +38,7 @@
38 38  
39 39  * number rpm – desired spindle rotation speed.
40 40  
41 -==== **void SpindleStartCCWRPM(number rpm)** ====
41 +===== void SpindleStartCCWRPM(number rpm) =====
42 42  
43 43  Turns on the spindle counterclockwise at the indicated rotation speed.
44 44  
... ... @@ -46,11 +46,11 @@
46 46  
47 47  * number rpm – desired spindle rotation speed.
48 48  
49 -==== **void SpindleStop()** ====
49 +===== void SpindleStop() =====
50 50  
51 51  Stop spindle rotation.
52 52  
53 -==== **bool GetSpindleAutoStop()** ====
53 +===== bool GetSpindleAutoStop() =====
54 54  
55 55  Allows you to check if the option to automatically turn off the spindle when stopping the G-code execution is active.
56 56