Skip to Content
Last modified by writer on 2024/02/28 16:48
From version 1.1
edited by writer
on 2024/02/28 16:47
Change comment: There is no comment for this version
To version 2.1
edited by writer
on 2024/02/28 16:48
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -17,15 +17,15 @@
17 17  
18 18  To calculate, go to "Configuration" → "Calibration Wizard" (with the controller selected and the machine turned on):
19 19  
20 -[[image:Configuration_Calibration wizard.png||data-xwiki-image-style-alignment="center" height="261" width="400"]]
20 +[[image:1709117297669-957.png||data-xwiki-image-style-alignment="center"]]
21 21  
22 22  1. Select the axis to be calibrated (i.e. the axis you want to calibrate).
23 23  1. Enter the speed of movement along the selected axis.
24 24  1. Enter the specified travel distance (this is the distance the selected axis will move; it is preferable to specify round, whole numbers to simplify measurements).
25 -The window also contains a display of the current number of STEP signals (the parameter is given for information).
26 -[[image:Calibration wizard Stage 1.png||data-xwiki-image-style-alignment="center" height="600" width="836"]]
25 +The window also contains a display of the current number of STEP signals (the parameter is given for information).[[image:1709117286806-215.png||data-xwiki-image-style-alignment="center"]]
27 27  1. Click on the "Run" button to move the selected axis to the previously specified distance and previously specified speed.
28 -As soon as the movement is completed, the right side of the "Calibration Wizard" window is activated (Stage 2).\\
27 +As soon as the movement is completed, the right side of the "Calibration Wizard" window is activated (Stage 2).
28 +[[image:1709117273846-740.png||data-xwiki-image-style-alignment="center"]]
29 29  1. Now it is necessary to measure the crossing distance as accurately as possible and enter the result into the "Measured distance" parameter (to make changes, then press the "Enter" button on the keyboard).
30 30  The new recalculated STEP value is displayed in the "Steps Per Unit calculated" parameter.
31 31