List of G-Codes Supported by the System
Last modified by writer on 2023/09/12 16:41
A short list of supported G-codes is given in the table below.
| G-Code | G-code description |
|---|---|
| G0 | Fast linear interpolation |
| G1 | Linear interpolation |
| G2, G3 | Circular interpolation |
| G4 | Dwell (pause) |
| G10 L2 | Setting the origin offset |
| G10 L20 | Setting the origin offset (calculated value) |
| G17 - G19.1 | Work plane selection |
| G28, G28.1 | Return to predefined position |
| G30, G30.1 | Return to predefined position |
| G38.x | Probing |
| G40 - G42 | Tool diameter compensation |
| G43, G49 | Tool length offset |
| G53 | Moving in machine coordinates |
| G54-G59.3 | Coordinate system selection |
| G61, G61.1, G64 | Choosing a tool path mode |
| G73 | Chip breaking drilling cycle |
| G80 | Cancellation of drilling, boring, threading cycles |
| G81 | Drilling cycle |
| G83 | Deep Drilling Cycle |
| G85 | Boring cycle with retraction at the working feed |
| G89 | Boring cycle with pause and retraction at the working feed |
| G90, G91 | Setting the absolute/incremental coordinate mode |
| G90.1, G91.1 | Setting the absolute/incremental coordinate mode for the center of the arc |
| G92 | Origin offset |
| G92.1, G92.2 | Cancel Offset G92 |
| G92.3 | G92 Offset Recovery |
| G93, G94 | Feed Job Format |
| G98, G99 | Z-level return mode in canned cycles |